Figure 59: I/O Configurator Empty; Figure 60: "Add I/O Modules" Button - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
8. The detected I/O modules then appear in the configuration window.
Passive I/O Modules
Remember that passive I/O modules, such as a power supply module (750-602)
or end module (750-600) will not be shown in the I/O configurator.

Figure 59: I/O Configurator Empty

You can use the [Add] button to add new I/O modules to manually define or
9.
change the configuration.

Figure 60: "Add I/O Modules" Button

Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
Run-time System CODESYS 2.3 215