Figure 86: Codesys - New Module Has Been Generated; Figure 87: Codesys - Enter The Event In A Global Variable - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
Figure 86: CODESYS – New Module has been Generated
Handling for the event that has occurred is now programmed in this new function.
In the example here, the event is documented in a global variable.
Figure 87: CODESYS – Enter the Event in a Global Variable
The newly created project is now supported and can be loaded to the controller.
After startup, the value of the "Events" variable changes only when counter "i"
reaches the value 0, meaning that division by 0 has been performed.
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
Run-time System CODESYS 2.3 235