WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
7.6.1.32
"Configuration of General SNMP Parameters" Page
The general settings for SNMP are given on the "Configuration of General SNMP
Parameters" page.
7.6.1.32.1 "General SNMP Configuration" Group
Table 91: WBM "Configuration of General SNMP Parameters" Page – "General SNMP
Configuration" Group
Parameter
Service active
Name of device
Description
Physical location
Contact
Click the [Submit] button to apply the changes. The changes only take effect after
restarting the controller. For this purpose, use the WBM reboot function. Do not
shut down the controller too early!
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
Explanation
Activate/deactivate the SNMP service.
Enter here the device name (sysName).
Enter here the device description (sysDescription).
Enter here the location of the device (sysLocation).
Enter here the email contact address (sysContact).
Commissioning
141