Configuration Of Snmp V3 Users" Page; Actually Configured V3 Users" Group(S); V3 User N" Group(S); Table 96: Wbm "Configuration Of Snmp V3" Page - "Actually Configured V3 Users" Group - WAGO I/O SYSTEM 750 Manual

144 Commissioning
</dg_
7.6.1.34

"Configuration of SNMP v3 Users" Page

The general settings for SNMP v3 are shown on the "Configuration of SNMP v3
Users" page.

7.6.1.34.1 "Actually Configured v3 Users" Group(s)

Table 96: WBM "Configuration of SNMP v3" Page – "Actually Configured v3 Users" Group
Parameters
Count

7.6.1.34.2 "v3 User n" Group(s)

A group with the following information is displayed for each user:
Table 97: WBM "Configuration of SNMP v3 Users" Page – "v3 User n" Group(s)
Parameters
Security Authentication
Name
Authentication Type
Authentication Key (min.
eight char.)
Privacy
Privacy Key (min. eight
char.)
Notification Receiver IP
Click [Delete] to delete the user. The changes only take effect after restarting the
controller. For this purpose, use the WBM reboot function. Do not shut down the
controller too early!
750-8208 PFC200 CS 2ETH RS CAN DPM
Explanation
The number of configured v3 users is displayed.
Explanation
The user name is displayed.
The authentication type for the SNMP v3 packets is
displayed here.
Possible values:
- Use no authentication ("None")
- Message Digest 5 ("MD5")
- Secure Hash Algorithm ("SHA")
The authentication key is displayed.
The encryption algorithm for the SNMP message is
displayed here.
Possible values:
- No encryption ("None")
- Data Encryption Standard ("DES")
- Advanced Encryption Standard ("AES")
The key for encryption of the SNMP message is
displayed here. If nothing is displayed here, the
"authentication key" is automatically used.
The IP address of a trap receiver for v3 traps is
displayed here. If no v3 traps are to be sent for this
user, this field remains blank.
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Manual