Changing An Ip Address Using The "Cbm" Configuration Tool Via The Serial Interface; Figure 31: Cbm Starting Screen - WAGO I/O SYSTEM 750 Manual

84 Commissioning
7.3.1 Changing an IP Address Using the "CBM" Configuration
Tool via the Serial Interface
You can also assign a new IP address to the ETHERNET interfaces X1 and X2
using the "CBM" configuration tool provided on the Linux
information about "CBM" is given in the Section "Configuration."
1. Link a PC to the X3 serial interface using a terminal program.
2. Log in to the Linux
The user name and the password are provided in the Section "Users and
Passwords" > "Linux
3. Start the configuration tool by entering the command "cbm" on the
command line and then press [Enter].

Figure 31: CBM Starting Screen

750-8208 PFC200 CS 2ETH RS CAN DPM
®
system as a "super user."
®
User Group."
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
®
console. More
Manual