Reset Button; Figure 21: Reset Button - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
3.5.2

Reset Button

Figure 21: Reset Button

The Reset button is installed behind drilling to prevent operating errors. It is a
shortstroke button with a low actuating force of 1.1 N ... 2.1 N (110 gf ... 210 gf).
The button can be actuated using a suitable object (e.g., pen).
You can initiate different functions using the Reset button depending on the
position of the mode selector:
- Temporarily set a fixed IP address
- Perform a software reset (restart)
- Restore factory setting (factory reset)
Please refer to the same sections in the back of this manual for information about
the functions.
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
Device Description 47