Figure 56: Control Configuration - Edit; Figure 57: "Start Wago-I/O-Check And Scan" Button - WAGO 750-8207 Manual

226 Run-time System CODESYS 2.3
3. Right-click on the entry "K-Bus[FIX]" and then select "Edit" in the contextual
menu. The "configuration" dialog window then opens.
Figure 56: Control Configuration – Edit
4. There are three options for accepting the topology for the I/O modules
connected to the fieldbus controller. The simplest way is to scan in the
topology using WAGO-I/O-CHECK.
To do this, click on the "Start WAGO-I/O-CHECK and scan" button.

Figure 57: "Start WAGO-I/O-CHECK and Scan" Button

Ensure proper installation of WAGO-I/O-CHECK!
This function requires that the latest version of WAGO-I/O-CHECK be installed
and the IP address set under "Online > Communication parameters", as
otherwise communication will not be possible.
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G