Ethernet" > "Switch Configuration" Submenu; Ethernet" > "Ethernet Ports" Submenu; Table 134: "Networking" > "Ethernet" > "Switch Configuration" Submenu; Table 135: "Networking" > "Ethernet" > "Ethernet Ports" Submenu - WAGO I/O SYSTEM 750 Manual

168 Commissioning
7.6.4.4.11 "Ethernet" > "Switch Configuration" Submenu
This submenu contains the settings for the Switch configuration.
Table 134: "Networking" > "Ethernet" > "Switch Configuration" Submenu
Submenu
0. Back to ...
1. Network interfaces
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
7.6.4.4.12 "Ethernet" > "Ethernet Ports" Submenu
This submenu contains other submenus with settings for the ETHERNET
interfaces.
Table 135: "Networking" > "Ethernet" > "Ethernet Ports" Submenu
Menu Item
0. Back to ...
1. Interface X1
2. Interface X2
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
750-8208 PFC200 CS 2ETH RS CAN DPM
Submenu Item / Explanation
Back to the higher-level menu
Enable or disable the switch.
0. Back to ... Back to the higher-level menu
Each interface is operated with its
1. Separated
own IP address.
Both interfaces are operated with one
2. Switched
IP address.
Explanation
Back to the higher-level menu
Opens a submenu with settings for the X1 interface
Opens a submenu with settings for the X2 interface
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Manual