Wagoconfigtoollib.lib; Figure 180: Graphical Representation Of The "Configtoolfb" Function Block; Table 315: Description Of The Configuration Scripts For "Information - WAGO I/O SYSTEM 750 Manual

432 Appendix
The document containing a description of this library and the function blocks it
includes is available for download on the Internet at www.wago.com.
15.2.1.9

WagoConfigToolLIB.lib

The following table shows call-ups that allow you to configure and parameterize
the controller from the PLC program or Linux
block (see parameter "stCallString"). In addition to WBM and the CBM, this is
another variant to configure the controller for operational requirements.
The configuration directory for this under Linux

Figure 180: Graphical Representation of the "ConfigToolFB" Function Block

Table 315: Description of the Configuration Scripts for "Information"

Parameters Status Call-Up
Controller Details: Identifies various information about the controller
Product
Description
Order Number
Firmware
Revision
Licence
Information
Network Details X1: Identifies the parameters currently used for the ETHERNET interface
X1/X2 in "switched" mode or for the ETHERNET interface X1 in "separated" mode
State
Mac Address
IP Address
Subnet Mask
Network Details X2: Identifies the parameters currently used for the ETHERNET interface
X2 in "separated" mode
See "Network Details X1". When calling these up, replace "X1" with "X2" (in "separated" mode
only).
</dg_
get_coupler_details
read
product-description
get_coupler_details
read
order-number
get_coupler_details
read
firmware-revision
get_coupler_details
read
license-information
get_actual_eth_config
read
X1 state
get_actual_eth_config
read
X1 mac-address
get_actual_eth_config
read
X1 ip-address
get_actual_eth_config
read
X1 subnet-mask
750-8208 PFC200 CS 2ETH RS CAN DPM
®
via the "ConfigToolFB" function
®
/etc/config-tools/
is:
Output/Input
Product description
Item number of the controller Immediately
Firmware version of the
controller
CODESYS license details
Status of the interface.
Possible return values:
- enabled
- disabled
Display of the MAC address
Display of current IP address
Display of the current subnet
mask
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Effective
Immediately
Immediately
Immediately
Immediately
Immediately
Immediately
Immediately
Manual