Profibus Slave Plc Configuration; Profibus Slave Basic Parameters; Figure 152: "Basic Parameters" Tab; Table 228: "Basic Parameters" Tab - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
11.1.3

PROFIBUS Slave PLC Configuration

The behavior of the PROFIBUS slaves can be defined using the tab described
below.
11.1.3.1

PROFIBUS Slave Basic Parameters

Figure 152: "Basic parameters" Tab

Table 228: "Basic parameters" Tab

Parameters
Module ID
Node ID
Input address
Output address
Diagnostic address
Comments
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
PROFIBUS DP-V1 Master
Description
Slave Ident.
Node number of slave used in the
CODESYS runtime environment.
Starting address for input data:
The address space always begins at
%IB10000 and is assigned
automatically. The starting address can
also be adjusted manually.
Starting address for output data:
The address space always begins at
%QB10000 and is assigned
automatically. The starting address can
also be adjusted manually.
Memory area for internal diagnostic
processing.
The slave can be assigned a unique
name here.
349