WAGO I/O SYSTEM 750 Manual page 355

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
Table 231: "User Parameters" Tab
Parameters
Module Extension
Process Data Representation
Response to PROFIBUS DP Failure
Response to K-Bus Failure
Start-up via DP/V1 channel
Slot Allocation
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
PROFIBUS DP-V1 Master
Description
Here it is possible to set whether or not
the internal data bus extension is used.
EEPROM setting is
used.
EEPROM setting is
not used.
Here it is possible to set the depiction of
the process values:
- INTEL (LSB-MSB)
- MOTOROLA (MSB-LSB)
Here it is possible to set the behavior of
the slave in the event of a PROFIBUS
failure:
- Write substitute values.
- Stop K-bus transmission
- Set initial image to zero.
- Freeze initial image.
Here it is possible to set the behavior of
the slave during a breakdown of the
internal data bus.- Stop PROFIBUS data
exchange.
- Set input image to zero.
- Freeze input image.
The DP/V1 operating mode can be
activated or deactivated here.
The compatibility of the slot allocation
can be set here.
DP/V1- To be selected when using
compatible CODESYS
S7 To be selected when using
compatible the S7 CPU
355
Activation of
internal data bus
extension.
Deactivation of
internal data bus
extension.