Figure 116: Basic Parameters Tab (Slave); Table 216: Description Of Basic Parameters (Slave) - WAGO I/O SYSTEM 750 Manual

310 CANopen Master and Slave
No input must be made on the Basic parameters tab.

Figure 116: Basic Parameters Tab (Slave)

Table 216: Description of Basic Parameters (Slave)

Parameters
Module ID
Node ID
Input address
Output address
Diagnostic address
Comment
750-8208 PFC200 CS 2ETH RS CAN DPM
Explanation
Recognition of the slave.
Node number of the slave used in the CODESYS
runtime environment.
Starting address for the input data:
The address space always begins at %IB 6000 and is
assigned automatically.
Starting address for the output data:
The address space always begins at %QB 6000 and
is assigned automatically.
Memory area for internal diagnostic processing.
Input field for comments.
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Manual