Profibus Master Bus Parameters; Figure 150: "Bus Parameters" Tab; Table 226: "Bus Parameters" Tab - WAGO I/O SYSTEM 750 Manual

346 PROFIBUS DP-V1 Master
11.1.2.3

PROFIBUS Master bus parameters

Figure 150: "Bus parameters" Tab

Table 226: "Bus parameters" Tab

Parameters
Baud rate (kBits/s)
Use defaults
Slot Time (TSL)
Min. Station Delay (min TSDR)
Max. Station Delay (max. TSDR)
Quiet Time (TQUI)
750-8208 PFC200 CS 2ETH RS CAN DPM
Description
Here it is possible to set the desired
baud rate for transmitting the data to the
PROFIBUS. The setting is dependent on
the PROFIBUS network (line length,
etc.)
If the control field is activated, the
settings under "Parameters" will be
automatically taken over from the GSD
file, depending on the baud rate.
Maximum time the master waits to
receive the first character in the reply
telegram from a slave after transmitting
a request telegram.
Minimum reaction time before a slave
replies.
Maximum reaction time for a slave to
reply.
Rest period to be taken into
consideration when switching over from
NRZ signals (Non Return to Zero) to
other codings.
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Manual