Configuration Of Dns Service" Page; Dns Service" Group; Table 88: Wbm "Configuration Of Dns Service" Page - "Dns Service" Group - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
7.6.1.30

"Configuration of DNS Service" Page

The settings for the DNS service are shown on the "Configuration of DNS
Service" page.

7.6.1.30.1 "DNS Service" Group

Table 88: WBM "Configuration of DNS Service" Page – "DNS Service" Group
Parameter
Service active
Mode
Static hosts
New static host
Click on [Submit] to accept the changes. The changes will be effective
immediately.
Click on [Add] to accept a new assignment. The change is effective immediately.
Click on [Delete] to delete an existing assignment. The change is effective
immediately.
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
Explanation
You can enable/disable the DNS server service here.
Select here the operating mode of the DNS server:
Requests are buffered to optimize
Proxy
throughput.
Relay All requests are routed directly.
This displays the static assignments of IP addresses
to names. If no assignment was defined, "No static
hosts configured" is displayed.
Enter here a new static assignment, e.g.,
"192.168.1.20:hostname."
You can enter 10 assignments.
Commissioning 139