WAGO I/O SYSTEM 750 Manual page 447

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
Table 327: Description of Configuration Scripts for "SNMP"
Parameters Status Call-Up
Configuration of SNMP v3
Any number of SNMP v3 users can be created. A user that has been set up is always active; the
complete data set must be deleted to deactivate a user.
Authentication
Name
Authentication
encryption type
Authentication
key
Privacy
encryption type
Privacy key
Trap receiver
address
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
get_snmp_data
read v3-auth-name
<Nummer>
get_snmp_data
read
v3-auth-type <Number>
get_snmp_data
read
v3-auth-key <Nummer>
get_snmp_data
read
v3-privacy <number>
get_snmp_data
read v3-privacy-key
<number>
get_snmp_data
read v3-notification-receiver
<number>
Output/Input
Specifies the user name for the
v3 user.
The <number> parameter
enables consecutive reading of
the related data from the
individually configured trap
receiver for a short period of
time (without interim changing
of the data). This is a consecutive
number that is not connected to
the data. If the number is not
included, the data of the first user
are read.
Specifies the type of encryption
that the v3 user uses (none,
MD5, or SHA).
Parameter <number> see
"Authentication Name".
Specifies the key string for
authentication.
Parameter <number> see
"Authentication Name".
Specifies the type of privacy
encryption for the v3 user (none,
DES, or AES).
Parameter <number> see
"Authentication Name".
Specifies the key string for
privacy. If nothing is entered, the
SNMP agent uses the
"Authentication Key".
Parameter <number> see
"Authentication Name".
IP address of an SNMP manager
that the agent traps for this v3
user are sent to. If nothing is
entered here, no traps are sent for
this user.
Parameter <number> see
"Authentication Name".
Appendix 447
Valid
Right
away
Right
away
Right
away
Right
away
Right
away
Right
away