Removing The I/O Module; Figure 179: Removing The I/O Module (Example) - WAGO I/O SYSTEM 750 Manual

396 Removal
14.1.2

Removing the I/O Module

1. Remove the I/O module from the assembly by pulling the release tab.

Figure 179: Removing the I/O Module (Example)

Electrical connections for data or power jumper contacts are disconnected when
removing the I/O module.
Do not take the controller enclosure apart!
The enclosure sections are firmly joined. The feed-in section with the CAGE
®
CLAMP connections cannot be separated from the other enclosure section.
750-8208 PFC200 CS 2ETH RS CAN DPM
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Manual