Tasks" > "Task N" Submenu; Plc Runtime" > "General Configuration" Submenu; Table 118: "Plc Runtime" > "Information" > "Tasks" > "Task N" Submenu; Table 119: "Plc Runtime" > "General Configuration" Submenu - WAGO I/O SYSTEM 750 Manual

160 Commissioning
7.6.4.3.8 "Tasks" > "Task n" Submenu
In this submenu, information on the selected task is displayed.
The submenu only appears when CODESYS 2 is enabled as the runtime system.
Table 118: "PLC Runtime" > "Information" > "Tasks" > "Task n" Submenu
Parameters
Cycle count
Cycle time (µsec)
Cycle time min (µsec)
Cycle time max (µsec)
Cycle time avg (µsec)
Status
Mode
Priority
Interval (msec)
To return to the higher-level menu, press [Q] or [Return].
7.6.4.3.9 "PLC Runtime" > "General Configuration" Submenu
This submenu contains other submenus with general settings for the runtime
system.
Table 119: "PLC Runtime" > "General Configuration" Submenu
Menu Item
0. Back to ...
1. PLC Runtime Version
2. Home Dir On SD Card
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
750-8208 PFC200 CS 2ETH RS CAN DPM
Explanation
Number of task cycles since the system start
Currently measured task cycle time for the task
Minimum task cycle time for the task since the
system start
Maximum task cycle time for the task since the
system start
Average task cycle time since the system start
Task status (e.g., RUN, STOP)
Task execution mode (e.g., in cycles)
Set task priority
Set task interval
Explanation
Back to the higher-level menu
Opens a submenu for the CODESYS runtime system
settings
Opens a submenu for the home directory settings
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Manual