Configuration Of Plc Runtime Services" Page; General Configuration" Group; Codesys 2" Group; Table 83: Wbm "Configuration Of Plc Runtime Services" Page - "General - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
7.6.1.26

"Configuration of PLC Runtime Services" Page

The settings for various services of the enabled runtime system are shown on the
"Configuration of PLC Runtime Services" page.

7.6.1.26.1 "General Configuration" Group

Table 83: WBM "Configuration of PLC Runtime Services" Page – "General Configuration" Group
Parameters
Port Authentication
Password
Confirm Password
Click [Submit] to apply change. The change is effective immediately.

7.6.1.26.2 "CODESYS 2" Group

Table 84: WBM "Configuration of CODESYS Services" Page – "CODESYS 2 Webserver" Group
Parameters
CODESYS 2 State
Webserver enabled
Communication enabled
Communication Port
Number
Port authentication enabled
Click [Submit] to apply change. The change is effective immediately.
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
Explanation
Enter the new password for port authentication.
Enter the new password again for confirmation.
Explanation
This displays the status (enabled/disabled) of the
CODESYS 2 runtime system.
Enable or disable the CODESYS 2 Webserver for
the CODESYS web visualization.
Enable or disable the communication between the
CODESYS 2 runtime system and the CODESYS 2
programming system.
Enter here the port number for communication with
the CODESYS 2 programming system. Default
value is 2455.
Define here whether port authentication is enabled.
If this is enabled, the password specified under
"General Configuration" must be entered when
logging in via CODESYS 2 IDE.
Commissioning 135