Figure 56: Control Configuration - Edit; Figure 57: "Start Wago-I/O-Check And Scan" Button - WAGO I/O SYSTEM 750 Manual
750-8208
pfc200 cs 2eth rs can dpm
plc - controller pfc200
Hide thumbs
Also See for I/O SYSTEM 750:
- Manual (296 pages) ,
- Quickstart reference (54 pages) ,
- Quick start manual (18 pages)
Table of Contents
Advertisement
WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
3.
Right-click on the entry "K-Bus[FIX]" and then select "Edit" in the
contextual menu. The "configuration" dialog window then opens.
Figure 56: Control Configuration – Edit
4.
There are three options for accepting the topology for the I/O modules
connected to the fieldbus controller. The simplest way is to scan in the
topology using WAGO-I/O-CHECK.
To do this, click on the "Start WAGO-I/O-CHECK and scan" button.
Figure 57: "Start WAGO-I/O-CHECK and Scan" Button
Ensure proper installation of WAGO-I/O-CHECK!
This function requires that the latest version of WAGO-I/O-CHECK be installed
and the IP address set under "Online > Communication parameters", as otherwise
communication will not be possible.
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
Run-time System CODESYS 2.3
213
Advertisement
Chapters
Table of Contents
Troubleshooting
