Task N" Group(S); Table 44: Wbm "Plc Runtime Information" Page - "Task N" Group(S) - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM

7.6.1.4.3 "Task n" Group(s)

This group is only visible if CODESYS 2 is enabled as the runtime system.
One dedicated group is displayed for each task when the PLC program is
executed. As a rule, only the group title is displayed with the task number, the task
name and the task ID.
Click [+] to expand the group and display the following information.
Table 44: WBM "PLC Runtime Information" Page – "Task n" Group(s)
Parameters
Cycle count
Cycle time (µsec)
Cycle time min (µsec)
Cycle time max (µsec)
Cycle time avg (µsec)
Status
Mode
Priority
Interval (msec)
To hide this information, click [–].
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
Explanation
Number of task cycles since the system start
Currently measured task cycle time for the task
Minimum task cycle time for the task since the
system start
Maximum task cycle time for the task since the
system start
Average task cycle time since the system start
Task status (e.g., RUN, STOP)
Task execution mode (e.g., in cycles)
Set task priority
Set task interval
Commissioning 101