Firewall Parameters Interface Xxx" Group; Table 55: Wbm "General Firewall Configuration" Page - "Firewall Parameter Interface Xn" Group - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM

7.6.1.10.2 "Firewall Parameters Interface xxx" Group

These settings in this group refer to the configuration of the firewall at IP level.
Table 55: WBM "General Firewall Configuration" Page – "Firewall Parameter Interface Xn" Group
Parameters
Firewall enabled for
Interface
ICMP echo protection
ICMP echo limit per second
ICMP burst limit
(0 = disabled)
Service enabled
Click [Submit] to apply the change. The change is effective immediately.
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
Explanation
Enable or disable the firewall for the specific
interface.
Enable or disable the "ICMP echo" protection for the
respective interface.
You can specify the maximum number of "ICMP
echo bursts" per second.
You can specify the maximum number of "ICMP
echo bursts" per second.
"0" = "Disabled"
Telnet
FTP
FTPS
HTTP
HTTPS
I/O-CHECK
PLC Runtime
PLC WebVisu –
direct link (port 8080)
SSH
TFTP
BootP/DHCP
DNS
MODBUS TCP
MODBUS UDP
SNMP
Commissioning
Enable or disable the
firewall for the respective
service.
The services themselves
must be enabled or disabled
separately on the "Ports and
Services" page.
111