Diaggetbusstate() And Diaggetstate(); Figure 162: Enable Channel Diagnostics 2 - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
5. The entry "Enabled" should appear in the "Values" column. If not, double-
click on the entry "Disabled" to enable the diagnostic channel in question.

Figure 162: Enable channel diagnostics 2

11.3.2

DiagGetBusState() and DiagGetState()

The following function blocks from the BusDiag.lib library are required to
evaluate the diagnostics:
• DiagGetBusState() for bus diagnostics
This function module provides general information on every connected
slave (e.g. number of slaves).
• DiagGetState() for subscriber diagnostics
This function block provides detailed information on each slave (e.g.
information on diagnostics).
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
PROFIBUS DP-V1 Master 361