Commissioning; Configuration And Parameterization With Wago-I/O-Check; Figure 39 Parameterization Dialog In Wago-I/O-Check - WAGO 750 Product Manual

Commissioning

6 Commissioning

6.1 Configuration and Parameterization with WAGO-I/O-CHECK

The I/O module can be configured with the WAGO-I/O-CHECK software.
To configure the I/O module with WAGO-I/O-CHECK, proceed as follows:
1. Open WAGO-I/O-CHECK.
2. Left-click on the [Identify] menu item. The node configuration is determined and dis-
played.
ð After the node structure has been identified in WAGO-I/O-CHECK, it appears in the
overview area.
The start view shows the parameterization dialog for the operating modes:
64 Product manual | Version: 1.1.0
Proportional Valve Module 2-3-4
Figure 39: Parameterization Dialog in WAGO-I/O-CHECK
750-1632/000-100