Libraries For A Profibus Link; Wago_Dpm_01.Lib; Wago_Busdiag_01.Lib - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
15.2.3

Libraries for a PROFIBUS Link

This section contains libraries supported by the controller 750-8208for linking
with PROFIBUS.
15.2.3.1

WAGO_DPM_01.lib

The controller 750-8208 supports the following function blocks of the
"WAGO_DPM_01.lib" library:
- DPM_VERSION
- DPM_GET_CONFIG
- DPM_GLOBAL_CONTROL
- DPM_READ_INPUT
- DPM_READ_OUTPUT
- DPM_SET_SLAVE_ADDRESS
- DPM_MSAC1_READ
- DPM_MSAC1_WRITE
Note the minimum PROFIBUS baud rate!
The function blocks of the WAGO_DPM_01.lib library can only be used for
PROFIBUS baud rates greater than or equal to 187.5 kBit/s.
Only assign slot numbers that have actually been programmed for the
"SLOT" input parameter!
When programming the "SLOT" input parameter, only slot numbers which have
actually been configured may be assigned.
This applies to all function blocks of the "WAGO_DPM_01.lib" library which
have the "SLOT" input variable.
The document containing a description of this library and the function blocks it
includes is available for download on the Internet at www.wago.com.
15.2.3.2

WAGO_BusDiag_01.lib

The controller 750-8208 supports the following function blocks of the
"WAGO_BusDiag_01.lib" library:
- WAGO_DiagGetBusState
- WAGO_DiagGetState
The document containing a description of this library and the function blocks it
includes is available for download on the Internet at www.wago.com.
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
Appendix 453