Trap Receiver N" Group(S); Add New Trap Receiver" Group; Table 94: Wbm "Configuration Of Snmp V1/V2C Parameters" Page - "Trap Receiver N" Group(S); Table 95: Wbm "Configuration Of Snmp V1/V2C Parameters" Page - "Add New Trap Receiver" Group - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM

7.6.1.33.3 "Trap Receiver n" Group(s)

A dedicated group with the following information is displayed for each trap
receiver:
Table 94: WBM "Configuration of SNMP v1/v2c Parameters" Page – "Trap Receiver n" Group(s)
Parameter
IP Address
Community Name
Version
Click [Delete] to delete the trap receiver. The changes only take effect after
restarting the controller. For this purpose, use the WBM reboot function. Do not
shut down the controller too early!

7.6.1.33.4 "Add New Trap Receiver" Group

You can enter 10 trap receivers.
Table 95: WBM "Configuration of SNMP v1/v2c Parameters" Page – "Add New Trap Receiver"
Group
Parameter
IP Address
Community Name
Version
Click [Add] to add a new trap receiver. The changes only take effect after
restarting the controller. For this purpose, use the WBM reboot function. Do not
shut down the controller too early!
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
Explanation
The IP address for the trap receiver (management
station) is displayed here.
This displays the community name for the trap
receiver configuration. The community name can be
evaluated by the trap receiver.
This displays the SNMP version, via which the traps
are sent: v1 or v2c (traps higher than v3 are
displayed in a separate form).
Explanation
Specify the IP address for the new trap receiver
(management station) here.
Specify here the community name for the new trap
receiver configuration. The community name can be
evaluated by the trap receiver.
The community name can be up to 32 characters
long and must not include spaces.
Specify the SNMP version that will send the traps:
v1 or v2c (traps higher than v3 are configured in a
separate form).
Commissioning 143