750-8208 Pfc200 Cs 2Eth Rs Can Dpm - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750

750-8208 PFC200 CS 2ETH RS CAN DPM

• WBM status:
This indicates whether the WBM is currently communicating with the
device in the background. In other words, one or more requests have been
sent and the browser is waiting for a response. Movement is then visible in
the graphic. This occurs when data is read on initial call-up of the page,
when the user has sent off a change form or when data is reloaded
automatically in cycles, e.g., the contents of the status area.
• Local Time:
Local time on the device
• Local Date:
Local date on the device
• PLC Switch:
Setting of the mode selector switch
• LEDs:
This indicates the status of the device LEDs. All LEDs are graphically
represented and are labeled with their particular designation (e.g., SYS,
RUN, ...). The following colors are possible:
-
LED is off.
-
The LED is activated in the particular color.
-
The LED is flashing in the corresponding color. The other half of the
surface is then either gray or also colored. The latter case indicates that the
LED is flashing sequentially in different colors.
A tooltip containing more detailed information opens as long as the cursor is
positioned over an LED. The text that is displayed also contains the message
that put the LED into its current status. The time of the message is also
shown.
The states displayed in the WBM will not always correspond at the precise
time to those on the controller. Data has a runtime during transmission and
can only be queried at a certain interval. The time period between two
queries is 30 seconds.
The contents of the individual pages and sub-pages are explained in the following
sections.
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
gray:
full color (green, red, yellow, orange):
half color:
Commissioning 97