Snmp" Menu; Snmp" > "General Snmp Configuration" Submenu; Table 176: "Snmp" Menu; Table 177: "Snmp" > "General Snmp Configuration" Submenu - WAGO I/O SYSTEM 750 Manual

198 Commissioning
7.6.4.12

"SNMP" Menu

This menu contains other submenus with the SNMP settings.

Table 176: "SNMP" Menu

Parameters
0. Back to ...
1. General SNMP
Configuration
2. SNMP v1/v2c Manager
Configuration
3. SNMP v1/v2c Trap
Receiver Configuration
4. SNMP v3 Configuration
5. SNMP firewalling
6. Secure SNMP firewalling
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
7.6.4.12.1 "SNMP" > "General SNMP Configuration" Submenu
This submenu contains the general SNMP settings.
Table 177: "SNMP" > "General SNMP Configuration" Submenu
Parameters
0. Back to ...
1. SNMP status
2. Name of device
3. Description
4. Physical location
5. Contact
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.
750-8208 PFC200 CS 2ETH RS CAN DPM
Explanation
Back to the higher-level menu
Opens a submenu with general SNMP settings
Opens a submenu with settings for the SNMP v1/v2c
Manager
Opens a submenu with settings for the SNMP v1/v2c
trap receivers
Opens a submenu with settings for the SNMP v3
configuration
Opens a submenu with firewall settings for SNMP
Submenu Item / Explanation
Back to the higher-level menu
Enable or disable the SNMP service.
0. Back to ... Back to the higher-level menu
1. Enable The SNMP service is enabled.
2. Disable The SNMP service is disabled.
Enter here the device name (sysName).
Enter here the device description (sysDescription).
Enter here the location of the device (sysLocation).
Enter here the email contact address (sysContact).
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Manual