Creating A Project And Selecting The Target System; Figure 51: Target System Settings (1); Figure 52: Target System Settings (2) - WAGO I/O SYSTEM 750 Manual

210 Run-time System CODESYS 2.3
8.2.2

Creating a Project and Selecting the Target System

In the menu bar click on File and select New. The "Target system settings"
1.
window then opens. Here, all available target systems that can be
programmed with CODESYS 2.3 are listed.
2. Open the selection box in the "Target system settings" window and select
the fieldbus controller you are using. In the example show here this is the
PFC200 CS 2ETH RS CAN DPM "WAGO_750-8208".
3. Click on [OK]. The "Target system settings" configuration window then
opens.

Figure 51: Target System Settings (1)

To accept the default configuration for the fieldbus controller click [OK].
4.
The "New component" window opens.

Figure 52: Target System Settings (2)

750-8208 PFC200 CS 2ETH RS CAN DPM
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Manual