146
Commissioning
</dg_
7.6.1.35
"Diagnostic Information" Page
The settings for displaying diagnostic messages are shown on the "Diagnostic
Information" page.
Table 99: WBM "Diagnostic Information" Page
Parameter
Read all notifications
Read only the last n
Automatic refresh cycle
(sec)
To refresh the display or to enable cyclic refresh, click the [Refresh] button. This
button is only visible if the cyclic refresh is not enabled or stopped.
To enable cyclic refresh, click the [Start] button. The button is only visible if
cyclic refresh is enabled and has not yet started.
To stop cyclic refresh again, click the [Stop] button. The button is only visible if
cyclic refresh is enabled.
The cyclical update is performed for as long as the "Diagnostic" page is opened.
If you change the WBM page, the update is stopped until you call up the
"Diagnostic" Page again.
The messages are displayed below the settings.
750-8208 PFC200 CS 2ETH RS CAN DPM
Explanation
Activate display of all messages.
Activate display of only the last n messages. You
also specify the number of messages to be displayed.
Select the check box to enable cyclic refresh.
Enter the cycle time in seconds in which a cyclic
refresh is performed. The label of the button
("Refresh"/"Start"/"Stop") changes depending on
status.
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Manual