Table 246: Diagnostics Run Led - WAGO I/O SYSTEM 750 Manual

376 Diagnostics

Table 246: Diagnostics RUN LED

Status
Green
Green flashing
Green/red flashing
Red
750-8208 PFC200 CS 2ETH RS CAN DPM
Explanation
PLC program has the
status "Run".
PLC program at a debug
point.
PLC is at a debug point
and the Run/Stop switch
has been set to "Stop".
No PLC-program loaded
or PLC program has the
status "Stop".
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Solution
---
Resume the program in
the linked IDE (Integrated
Development
Environment) using
"Single step" or "Start". If
the connection has been
interrupted, set the
Run/Stop switch to "Stop"
and then back to "Run" to
enable the program to
continue.
Set the Run/Stop switch to
"Run" to enable the
program to continue.
Load the PLC program.
Set the Run/Stop switch to
"Run" to start the current
program.
Manual