WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
11.2
Access to PROFIBUS Process Data
The inserted I/O modules appear with the associated, fixed addresses in the PLC
configuration under the slave "WAGO 750-343". Personal variables can be
declared for the inputs and outputs of these I/O modules.
To declare variables, proceed as follows:
1.
Click the "Resources" tab and open the PLC configuration.
2.
Double-click on the "AT" entry (next to the arrow) and enter a variable
name. In this example, the names "PB_Input_Bit" and "PB_Output_Bit"
were assigned.
Figure 157: PLC configuration: I/O modules with associated addresses
Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
PROFIBUS DP-V1 Master
357