Figure 38: "Wago Ethernet Settings" - "Network" Tab; 750-8208 Pfc200 Cs 2Eth Rs Can Dpm - WAGO I/O SYSTEM 750 Manual

88 Commissioning
Click [Identify] to read in and identify the connected controller.
5.
6. Select the "Network" tab:
Figure 38: "WAGO Ethernet Settings" – "Network" Tab
7. To assign a fixed address, select "Static configuration" on the "Source" line
under "Input". DHCP is normally activated as the default setting.
8. In the column "Input" enter the required IP address and, if applicable, the
address of the subnet mask and of the gateway.
9. Click on [Write] to accept the address in the controller. (If necessary,
"WAGO Ethernet Settings" will restart your controller. This action may
require about 30 seconds.)
10. You can now close "WAGO Ethernet Settings", or make other changes
directly in the Web-based Management system as required. To do this, click
on [WBM] at the right in the window.

750-8208 PFC200 CS 2ETH RS CAN DPM

Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Manual