Profibus Slave User Parameters; Figure 155: "User Parameters" Tab; Table 231: "User Parameters" Tab - WAGO I/O SYSTEM 750 Manual

354 PROFIBUS DP-V1 Master
11.1.3.4

PROFIBUS Slave User Parameters

Figure 155: "User Parameters" Tab

The parameters shown apply for the PROFIBUS coupler (750-343) used as an
example.
Other parameters may be used for other components.

Table 231: "User Parameters" Tab

Parameters
Symbolic names
Restarting on K-Bus failure
Device diagnostics
750-8208 PFC200 CS 2ETH RS CAN DPM
Description
These are used to alter the
representation of values (text
coded/binary coded).
The starting behavior of the slave
following an error can be set here.
AUTORESET Automatic slave start
POWER ON
RESET
The slave subscriber diagnostics can be
activated or deactivated here.
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
To start the slave it is
necessary to first
switch off the power
supply and then switch
it back on.
Manual