General Plc Runtime Configuration" Page; General Plc Runtime Configuration" Group; Table 45: Wbm "General Plc Runtime Configuration" Page - "General Plc Runtime Configuration" Group - WAGO I/O SYSTEM 750 Manual

102 Commissioning
7.6.1.5

"General PLC Runtime Configuration" Page

The settings for the boot project created with the programming software are given
on the "General PLC Runtime Configuration" page.

7.6.1.5.1 "General PLC Runtime Configuration" Group

Table 45: WBM "General PLC Runtime Configuration" Page – "General PLC Runtime
Configuration" Group
Parameters
PLC runtime version
Home directory on memory
card enabled
All data is deleted when switching the runtime system!
The runtime system's home directory is completely deleted when switching the
runtime system!
Insert a memory card before switching the home directory!
When moving the home directory to the memory card, insert a memory card
formatted to support file system. Only the first partition of a memory card can be
accessed at /media/sd and can be used as the home directory.
Perform a reset before switching the home directory!
Stop IEC-61131 applications in use before switching the home directory of the
runtime system.
Restore the device to its initial state using the "Reset" function. Any boot project
is deleted.
Click [Submit] to apply the change.
The runtime system change is effective immediately.
The home directory change takes effect after the next restart.
750-8208 PFC200 CS 2ETH RS CAN DPM
Explanation
Select here the PLC runtime system to be enabled.
None No runtime system is enabled.
CODESYS 2 runtime system is
CODESYS 2
enabled.
Define if the home directory for the runtime system
should be moved to the memory card.
The home directory is stored in
Disabled
the internal memory.
The home directory is moved to
Enabled
the memory card.
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Manual