Subaru 1600 Service Manual page 750

ELECTRICAL SYSTEM
8. Remote Controlled RearView Mirror (Option)
The remote controlled rearview mirror
switch consists of a left-right change-
over select knob and a control lever.
The switch is ready to function only
when the ignition-starter switch is in
"ACC" or "ON". To set the rearview
mirror positions, move the select knob
to the left for the left rearview mirror
or to the right for the right one and
move the control lever to left, right,
up or down. Movement of the mirror
is accomplished by the motor in the
mirror. After releasing the control
lever when the mirror is in the desired
position, the motor stops automati-
cally.
Replacement of the Switch
Remove the console box or radio box.
Disconnect the 6-pin connector from
the rear, remove the dress nut and
replace the switch.
Replacement of the Electrical
Wiring
The wiring is routed from the instru-
ment panel wiring harness connector
to the rearview mirror via the front
door cord and the rearview mirror
cord. The front door cord can be
removed after detaching the grommet.
The rearview mirror cord can be
detached by removing the two retain-
ing clips. To install, remove the door
window glass, and make sure the glass
and cord do not interfere with each
other after installation.
Fig. 15-268
Instrument panel
wiring harness
Fig. 15-269
Front
door
cord
Detail "A"
15-87
Cross sectional view of
mirror
Remote controlled rearview
mirror switch
A25-822
Detail "8"
A25-823