Subaru 1600 Service Manual page 628

• Door Glall
Removing and installing procedures
are common to the front and rear
door glasses.
1) Detach trim panel and sealing
cover.
2) Remove outer weatherstrip.
3) Remove upper stoppers at the
front and rear of door by loosening
bolts, and detach two bolts fixing glass
holder to regulator channel A.
A24·488
Fig. 14·108
NOTE:
a. It il recommended to mark each
part before removal to facilitate
adjustment.
b. Whan removing the bolt of regula·
tor channel A, lower the gla .. until
the bolt comel in the .. rvice hole.
c. Never turn regulator in cloling
direction while gla. il removed,
otherwi .. the gear might be dil'
engaged.
4) Hold glass by both hands with
door openec1, and then pull it out
upward while pushing it slightly
against the front sash side (for 4·Door
Sedan and Station Wagon) or the
rear sash side (for 2·Door Hatchback
and Hardtop).
~
o
A24·IOO
FIg.
14·109
BODY
5) Installation can be carried out in
the reverse order of removal.
Tlahten1na torque
for reBulator
channel A flxlnB
Icrews
NOTE:
7 - 8 N·m
(0.7 - 0.8 ka-m,
5.1 - 5.8 fi·lb)
Place the claw of glan holder lecurelv
on the regulator channel A.
1 Claw
2 Relulator channel A
A24·IO'
Fig. 14·10 P/lelng e/lw onto "gu/lror
ehlnn,'
A
• Door Olall Regulator and
Sish
Although following description II
based on front window reaulator,
removal and Installation of rear
window regulator can be carried out
in the same manner al that for the
front window regulator.
1) Removil
1) Detach trim panel and lealing
cover.
2) Remove outer weatherstrip and
end of door weatherstrip, and then
take out door gla ••.
3) Remove four boltl fixina reau1a·
tor bale plate and two boltl fixina
reaulator channel B.
4) Take out reaulator ASSY throuah
the lower work hole of door panel.
14-33
A24·I02
Fig.
14·111
R,movlng ",ullror
5) Remove all nutl, and take out
lash through the opening for the alall.
FIg.
14·112
2) Inspection
Check rel\1lator for followinl Iteml,
and replace with new one or repair
it
if defective.
a. Gear for exee'live wear
b. Spring for breakaae
e. Other component partl fOf damale
or abnormal wear
d. Each sliding portion for proper
lubrication
AI4·IOI
FIg.
14·1'13
Wlndow,."ul'tor