Subaru 1600 Service Manual page 631

• Fitting Adjustment
1)
Remove gas stays and striker,
loosen bolts fixing rear gate hinge to
the body, and then adjust the gaps
into the dimensions shown in follow-
ing figures
by
shifting the door.
Aoof
7.6:1: 1.6 (0.299:1:0.069)
Aelr glte
Unit: mm (In)
Section A-A
6.6:1: 1.6 (0.220:1:0.069)
Section B-B
Relr qUlrter
penel
Unit: mm (In)
• Mlrked dlmenllon Ihould
be equll .t both Ild.l.
A24·1128
Fig. 14-119 Adjusting gBfJS
(2-000r Hstchbsck)
A24·1130
Fig. 14-120 Adjusting hinge position
(2-000r HstchbllCk)
BODY
7.4:1: 1.6 (0.291:t0.069)
Aoof
Relr
glte
Unit: mm (In)
Section A-A
Unit: mm (in)
Section B-B
• Mlrkld dimenllon Ihould
be equII It both lid ...
Fig. 14-121 Adjustinggsps
(Ststion Wsgon)
A24·1131
A24·1132
Fig. 14-122 Adjusting hlng, position
(Ststlon Wsgon)
14-38
2) Adjust striker as follows
a. To make sidewise and longitudinal
adjustments of striker, loosen fixing
bolts and shift the striker.
NOTE:
a. Make sidewise adjustment with
special attention so as to align the
centers of striker and latch. With
the striker fixed temporarily, en-
gage it with the latch, and it will
Ihift to aligned pOlition.
b. Make longitudinal adjultment so al
to provide proper gaps to the body
and to provide proper fitting pres-
sure of weather Itrip.
In ca. of Station Wagon, this
adjultment Ihould be made with
key lock locked.
b. Make vertical adjustment by placing
spacer on fixing surface of the
striker so as to provide specified
dimensions as shown in the fol-
lowing figures with ' " marked.
2·000r Hltchblck
A24·1133
Stltlon Wlgon SPlclr
A24-888
Fig. 14-123 Plsclng spIcer
I· 1.11