Subaru 1600 Service Manual page 448

8) Install lock pin boot to caliper
body. Apply Silicon Compound
(725IQI050 or 00360(010) to the
inside of lock pin boot and around
sleeve. Then insert sleeve into lock pin
boot.
''1\
~L?
'//
~
~\
\
LSleeve
- Lock pi n boot
A17-313
Fig. 10-39 Installing lock pin boot
and sleeve
A3-266
Fig. 10-40 Grease application to lock
pin portion
9) Rotate piston until the notch at
the head of piston comes in alignment
with the center of disc, and make sure
that all parts are properly attached.
10) Install support to housing.
I
Torque
~upport bolt)
49 - 69 N'm
(5.0 - 7.0 kg-m,
36 - 51 ft-Ib)
A17-307
Fig. 10-41 Installing support
BRAKES
11) Install outer pad clip and inner
pad clip properly.
~ t
Install clip with this longer
\ portion facing outward.
/
I Outer pad dip
2 I nner pad clip
3 Inner pad clip
Fig. 10-42 Installing pad clips
A17-314
12) Install outer pad and inner pad
properly.
1:1) Make sure that caliper body and
support are properly coated with
grease. Insert the support guide pin
into the fitting hole in caliper body.
Tighten lock pin to the specified
torque.
A3-265
Fig. 10-43 Grease application to
guide pin portion
--~1-'
16- 24 N·m
Torque (J 6 - 24 k -
I
(Lock P;0)_,12 .. 17
ft~;"
NOTE:
a. Use only Silicon Compound
(725191050 or 003606010) grease
for the guide pin and lock pin
portions.
b. After assembly, make sure that
boots are properly fitted in the
grooves on the guide pin and sleeve.
c. If the boot contains too much air
and is expanded, press it to purge
out some air.
10-11
14) Make sure that all parts are
properly attached, then connect brake
hose and hand brake cable.
NOTE:
Replace brake hose gaskets with new
ones.
IS)
Bleed air from the brake system.
l ·
~:irrq~l~e:~r-l
:t' =
~.~~~~j
screw) 5. J -, 6.5 ft-lb)
- - . .
----
------.---.----~-