Subaru 1600 Service Manual page 609

b. Second, fit the front upper corner
in the same manner as above.
c. Then fit remaining portion to the
flange.
NOTE:
a. Fit weatherstrip by tapping with
rubber hammer.
b. Never hit weatherstrip too strongly,
otherwise the flange might be de-
formed.
c. Since the groove of the weather-
strip serves to fix the trim panel, fit
weatherstrip to the body flange
with depressing trim panel toward
the body flange so as to place it
underneath the weatherstrip.
2) Install hinges and lock assembly
to the glass with screws.
NOTE:
a. To engage nut plate and hinge
or lock, align flats of them.
b. Tighten the screws temporarily in
this step, and tighten securely after
glass position adjustment is made.
Nut plate
A24-433
Fig. 14-27 Aligning flats of nut plate
and hinge or lock
3) Install the glass assembly to the
body by tightening screws while ad-
justing the glass position.
BODY
3. Side Window on Hardtop
1 Retainer
2 Roof side weatherstrip
3 Side window weatherstrip
4 Stopper B
S Outer weatherstrip
Fig. 14-28 Component parts
1) Adjustment
Adjustment of the side window glass is
carried out with roof side weatherstrip
dismounted.
6
7
8
9
10
Fig. 14-29 Side window glass adjustment
14-14
I ,
Corner patch
Stopper A
Adjust nuts
Regulator
Guide plate
A24-439
Since adjustment of side window glass
depends upon adjustment of door glass
adjustment, first adjust door glass
according to the door glass adjusting
procedure.
Stopper A
Stopper B
A24-448