Subaru 1600 Service Manual page 415

3) Temporarily lock outer bush with
lock bolt.
A15·162
Fig. 9-44 Temporarily locking outer
bush
4) Install inner arm to crossmember.
Torque
74 - 93 N·m
(7.5- 9.5 kg-m,
54 - 69 ft-lb)
L -_ _ _ _ _ _ _ _
L -_ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Fig.9-45 Installing inner arm
5) Connect inner arm and outer arm.
Torque
1 Connecting bolts
2 Outer arm
3 Inner arm
4 Crossmember
118 - 147 N·m
(12.0 - 15.0 kg-m,
87 -108 ft-lb)
®
/ CD
A15-163
Fig. 9-46 Connecting inner arm and
outer arm
SUSPENSION, WHEELS AND AXLES
6) Install shock absorber to inner
arm at lower end of shock absorber.
Torque
88-118N·m
(9.0 - 12.0 kg-m,
65 -- 87 ft-lb)
A15·119
Fig.9-47 Installing shock absorber
4. Installation
1) Support rear crossmember at its
center with a jack, and set it in
position.
Fig.9-48 Supporting rear
crossmember
NOTE:
A16-116
When setting crossmember to vehicle
body, insert 13 mm (0.51 in) diameter
of bar into holes on crossmember
bracket and body frame to facilitate
the job by aligning the holes.
9-20
A15·126
Fig.
9-49
Aligning holes
2) Tighten the four bolts holding
rear crossrnember at both ends.
Torque
Fig. 9-50
118 -147 N·m
(12 - 15 kg-m,
87 - 108 ft-lb)
A16-117
3) Connect brake hose and brake
pipe on both sides.
Torque
NOTE:
12 - 18 N·m
(1.2 - 1.8 kg-m,
9 - 13 ft-lb)
Use suitable flare nut wrench.
Fig. 9-51