Subaru 1600 Service Manual page 111

13-14mm
(0.51-0.55
in)
98N
(10 kg. 22 Ib) "
Crank·
shaft
Fig.3-183 Drive belt tension
OM· tOt
39) Install distributor as follows.
a. Set #1 piston at its top dead
center in the compression stroke.
b. Align the distributor matching
marks.
ENGINE
c. Install distributor plate on crank-
case with bolt.
HITACHI
AS·SOS
Fig.
3-184
Aligning distributor
matching marks
d. Apply oil to the circumference of
distributor shaft and gear.
3-74
e. Install distributor into crankcase
taking care not to damage distributor
gear and O-ring.
f. Connect vacuum hoses to dis-
tributor.
g. Clip the distributor lead wire.
NOTE:
Be careful that the holes in the
distributor plate and crankcase are
correctly lined up.
40) Connect spark plug cords to
spark plugs and cord supporters and
distributor cord to cord supporter.
41) Install oil level gauge if it has
been removed.
42) Install carburetor protector. [For
49 States (except 4WD & 4WD·AT)
and California]
43) Remove Engine Stands
(399814300).