Subaru 1600 Service Manual page 629

NOTE:
Apply grease to the location indicated
by arrows in the above figure.
3) Installation
Reverse the steps in removal.
Torque
Regulator
7 - 8 N'm
mounting
(0.7 - 0.8 kg·m,
bolts 5.1 - 5.8 ft.lb)
Sash
10-12N·m
fixing
(1.0 - 1.2 kg·m,
nuts 7 - 9 ft.lb)
NOTE:
a. When mounting regulator to door
panel, first tighten four bolts of
base plate and then tighten two
bolts for regulator channel B
while making proper adjustment
b. In case of front door, for 4-Door
Sedan and Station Wagon front
sash has
c..=J
shaped section and
rear sash has
C
shaped section,
and vice versa for Z·Door Hatch·
back and Hardtop.
BODY
4. Power Window
(Option)
Switches for power window are pro·
vided on doors (except front passenger
side door) instead of window regulator
handles, and window regulator of each
door has a electric motor. Removal,
installation and adjustment procedures
are common to the door with (manual)
window regulator.
A24-695
Fig. 14-114 Switch for power window
A24-696
Fig. 14-115 Window regulator for
power window
14-34
NOTE:
a. When removing trim panel, discon·
nect electric wires at connectors.
Fig. 14-116 Electric wires and
connectors
A24-697
b. When taking out window regulator,
also disconnect electric wire at
connector.
_h~1
.,I"t,.,t, .... ,_ ...
~~.~.
_._' .... , _ _ _ _ _ . , . . - - - -_ _ _ _ - -_ _ _ - - - -_ _ _ _ _ _ _ _