Subaru 1600 Service Manual page 818

ELECTRICAL SYSTEM
B. BRAT
a) When chime does not sound and also fasten seat belt warning light does not turn on;
Turn ignition-starter switch
to ON position while driver's
seat belt is not fastened.
*1
Use circuit tester, and meas- No Inspect fusible link, connec-
ure whether voltage at ON
r--~
tor and wire between battery
tenninal (2-B) of ignition- and ignition-starter switch.
starter switch is 12V or not.
Yes
Use circuit tester, and meas- Inspect fuse (lOA), connector
ure whether voltage at ter-
~N._o_--t
and wire between ignition-
minal
CD
(O.5-LW) is 12V starter switch and timer.
or not.
Yes
• Replace fusible link if it is
blown.
• Repair connector and
wire.
• Replace fuse if it is blown.
1---......
Repair connector and
wire.
• See if timer discharges No Poor connection between
I--_~
Repair connector or replace
intermittently out-put
~-_"'I
timer and its connector, or timer.
voltage between its termi- defective timer. ~------------I
nals
@
(O.5-WL) and
®
(0.5-B).
• Check for continuity be-
tween tenninals
@
(0.5-
GB) and
®
(0.5-B) of
timer for 6 seconds after
ignition-starter switch is
turned to ON.
Yes
Inspect connector and wire
between timer and ground.
I---~
Repair connector and wire.
*1: Never leave the switch in ON position all the way.
15-155