Subaru 1600 Service Manual page 747

• Cruise control switch
Terminll
CRVISE
OFF
1 Q
3
6
4
Fig. 15-263 Main switch
~
T.rmin~
1 2
ClI>OrOti~
~.~~ ~.~~
CRUISE
RESUME
0-
ro
COAST
SET
,..,
Fig.
15-264
Sub-switch
Replace main switch and/or sub-switch
as
follows.
1) Lower steering column.
2) Remove steering wheel cover.
3)
Remove steering wheel.
4) Divide steering column cover in
two, then remove electric connector.
5) Remove four tapping screws from
the back of the column cover, then
replace main switch.
6) Remove sub-switch from ignition-
starter switch by loosening two screws,
then install a (new) sub-switch there.
NOTE:
When installing column cover, be
careful to prevent electric wire from
becoming entangled with 01ller parts.
3
~~
,..,
ELECTRICAL SYSTEM
Wiring
AEX 0.3 R
LEO
AEX 0.3
Br
F.:::\
\.!Y J
AEX 0.3 B
.A· vv
R560n
A25-630
Resume
4
~~X
0.3W
J"\
A25-631
• Outch switch (MT vehicle only)
Fig. 15-265
15-84
1)
To remove or install clutch switch,
remove connector for the switch and
nut (B) on the underside of the switch.
Tightening
torque
(Nut B)
5.4 - 9.3 N·m
(0.55 - 0.95 kg-m,
4.0 - 6.9 ft-Ib)
2) Adjust the free play of clutch
pedal by loosening or tightening nut
(B) on the underside of clutch switch.
Free play of
clutch pedal
NOTE:
13 - 20mm
(0.51 - 0.79 in)
Before starting the adjustment, electric
connector should be removed to pre-
vent the wire from being twisted.
Firmly connect the connector after
the adjustment.
9) Cable Play Adjustment
• Vehicle with HITACHI carburetor
Adjust cable play in the following
procedure by retightening nuts
CD,
@
and@.
1) Adjust dimension "A" between
the stopper and lever in the link ASSY
to approx. 2 mm (0.08 in) while
pulling the cable at position
4
toward
the throttle lever, and then retighten
nuts
CD.
2) Adjust deflection "B" to less than
20 mm (0.79 in) [or free play "C" to
less than 4 mm (0.16 in)] without
movement of the throttle lever, and
then retighten nuts
@.
3)
Loosen nuts @ and detach the
grommet of the actuator. Retighten
nuts @ so that the throttle lever will
start moving when pushing the dia-
phragm in the actuator by approx.
5 mm (0.20 in).