Subaru 1600 Service Manual page 607

• Front
1) Removal
I) Raise windshield wiper arm for-
ward.
2) Turn up the lip of weatherstrip
from the passenger compartment, and
force it out of body flange.
This is to be carried out on the top
and along about half of the side of the
glass.
3) Push out glass along with weather-
strip and mouldings from the passenger
compartment.
NOTE:
a. Apply an even force to glass at the
portion near weatherstrip.
b. If weatherstrip will not be reused,
cut it off with a knife and take it
out.
A24-415
Fig. 14-14 Pushing out windshield
4) Detach mouldings from weather-
strip.
2)
Installation
1) Wipe sealing compound off
weatherstrip with kerosene.
2) Attach weatherstrip to glass, and
then fit work cords into the grooves of
weatherstrip.
I Work cord
2 Weatherstrip
A24·032
Fig.
14-15
Fitting work cords
BODY
NOTE:
a. Overlap the end of work cord at the
bottom of glass.
A24-416
Fig. 14-16
b. After work cords are fitted to
weatherstrip, apply kerosene to the
entire edge of weatherstrip.
3) Fit mouldings into the groove of
weatherstrip.
4) Position glass properly from out-
side, and bring work cords into
passenger compartment.
S)
Apply kerosene along the entire
lip of weatherstrip.
6) Pull out the lip of weatherstrip for
the end of roof trim, and then fit
weatherstrip in such a manner that the
lip moves over body flange while
tapping glass with hand from the
outside and pulling work cord from
passenger compartment.
A24·418
Fig. 14-17 Installing windshield
NOTE:
a. Work should proceed from the
center of the glass to the left and
right.
b. Push or tap the glass by hand but
don't tap mOUldings.
c. Fit weatherstrip correctly to the
body.
7) Insert a spatula in between
weatherstrip and the flange of body,
and move it along the entire length
of weatherstrip.
14-12
@
1 Glass
2 Weatherstrip
3 Spatula
4 Body
4
A24-419
Fig. 14-18 Adjusting weatherstrip
8) Settle the whole glass in the body
by tapping it with hand or a rubber
hammer.
9) Apply sealing agent (Starseal
U-70).
Wipe off exuded sealing agent.
CD
A24-420
A24-089
Weatherstrip
Glass
Fig. 14-19 Applying sealing agent
• Rear
Removal and installation of rear
window glass can be carried out in the
same manner as in the front wind-
shield.
NOTE:
When replacing slide glass on 4WD
Open M.P.V. GL model, insert (new)
slide glass into sash while expanding it.
I, II
·~'~~'·''''·~~·~~~~~4->''''''''''''''''''''''''''''''''''I'-j'"~il
I ...... •• - - - ' ... ,--,_ ... , - - - - - - - - - - - - - - - - - - -