Subaru 1600 Service Manual page 802

When the lighting switch is
set to the I st or 2nd step, the
parking light, tail light, and/
or license light will not light.
Check after having set the]
lighting switch to the 1st
step.
Check if the fuses
#
11 (15 A/
license, tail, and parking
lights) are not blown.
No
Check if the voltage is 12 V at
the terminals 0.85 RW on the
loaded sides of the fuses
(15 A/license, tail, and park-
ing lights).
Yes
Remove the lighting switch,
and check if there is conduc-
tion between 0.85 RW and
0.85 R when set to the 1st
and 2nd steps.
Yes
ELECTRICAL SYSTEM
Yes~ I-----------------~
1
Check the cause and repair.
~~-
...
~~{
Replace the fuse.
No
• Connection of lighting
relay connector is poor, or
the relay is defective.
• The connector is in faulty
contact or the fusible
link
is blown.
t-_N_o_Ool The contact on the switch is
• Replace lighting relay.
t - - -....
_~. Repair the connector or
replace the fusible link.
I .
defective.
1------.1
1
Replace the sWitch.
~--------------~
I
The connector is in faulty
contact with the harness or
' - - - - - - - - - - -....
~-J
the wiring is broken
bet~een ~_~
Repair the connector or
the lighting switch and each harness.
light. "'"---_ _ _ _ _ _ _ _
.....J
15-139