Subaru 1600 Service Manual page 510

8) Adjust the backlash of rack and
pinion as follows:
a. Tighten adjusting screw until sleeve
contacts rack [5 N·m (0.5 kg-m,
3.6 ft-lb) torque] . Back the adjuster
out 1/2 turn.
b. Tighten adjusting screw until it gets
tight. Back it out 30° (1/12 turn).
c. While holding the adjuster, tighten
lock nut.
Torque
29 - 49 N·m
(3 - 5 kg-m,
22 - 36 ft-lb)
STEERING SYSTEM
9) Check the adjustment by turning
the input shaft in both directions by
hand. If excessive tightness, binding or
looseness is felt, repeat the adjustment
procedure.
4) Installation
As for the following service procedures
and checkings, refer to the power
steering section in this chapter.
a. Installation of gearbox.
b. Piping of fluid line.
c. Oil level.
d. Steering condition.
e. Fluid leakage.
f. Noise and vibration.
g. Clearance.
h. Measurement of steering effort.
NOTE:
It is recommended to recheck the
above after several days.
11-8. Oil Pump (Power Steering System)
1. Construction
r---
I
@
®
Tightening torque N·m (kg-m, ft-Ib)
T1: 14 - 18 (1.4 . 1.8, 10 - 13)
T2: 44 - 54 (4.5 - 5.5, 33 - 40)
Fig. 11·119
I
®
CD
I
11-37
I
(j)
Spring washer
Bolt
Spring washer
Bolt
Flange nut
Stay
Supporter
Spring washer
Bolt
Hose clamp
A18-361