Subaru 1600 Service Manual page 77

NOTE:
Be careful to prevent mainshaft splines
from interferinll with clutch diaphragm
spring. This can cause damage to
sprinll·
A4-200
Fig.349 Turning crankshaft
a. Temporarily tighten upper two
bolts, and then lower nuts.
b. Make sure that engine is properly
aligned with transmission.
c. Securely tighten both upper bolts
and lower nuts.
Torque
(Bolts and
nuts)
46 - 54 N·m
(4.1 - 5.5 kg·m,
34 - 40 ft·lb)
3) Put engine in position as follows.
a. Lower the jack supporting transmis·
sion, and take it out.
b. Position engine mount rubbers onto
crossmember.
c. Lower engine moreover.
d. Detach lifting wire from engine,
and carry away crane.
4) (AT only) Install drive plate on
torque converter as follows:
a.
Jack up the car until front wheels
are slightly off the floor.
b. Turning crank pulley with a wrench,
bring the mounting hole for drive
plate to the center of the timing
hole.
c. Turn front wheels until the mount·
ing holes for torque converter are
aligned with the mounting holes for
drive plate, and tighten them by
bolts ..
d. Crank engine with a wrench and
securely tighten all four mounting
bolts - one bolt at a time for each
turn - to retain torque converter
and drive plate.
Torque
NOTE:
ENGINE
23 - 26 N·m
(2.3 - 2.1 kg·m,
11- 20 ft-lb)
•
Be careful not to drop bolts into
torque converter housinll.
A4·112
Fig. 3·50 Connecting torque con-
verter and drive plate
5) Raise the vehicle with a jack just
enough to work underneath it and
support with safety stands.
6) Securely tighten engine mount
cushion rubbers on the crossmember.
Torque
20- 33 N'm
(2.0 - 3.4 kg-m,
14 - 25 ft-Ib)
A4·095
Fig.3-51 Tightening cushion rubber
nuts
1) Connect front exhaust pipe to
engine as follows.
a. Attach new gaskets to the engine
exhaust ports, and temporarily
tighten nuts.
NOTE:
Place the flat surface of the gasket to
the enlline exhaust port.
3-40
I
I I
r
~
1$''.1 Gasket
An-031
Fig. 3·52 Installing gasket
b. Tighten bolt at bracket of body.
Torque
25 - 34 N·m
(2.5 3.5 kg-m,
18 - 25 ft-Ib)
A4·161
Fig. 3·53 Installing front exhaust
pipe
c. Then tighten four nuts to the speci·
fied torque.
Torque
Fig. 3-54
25 - 29N·m
(2.6 3.0 kg-m.
19
22 ft·lb)
It:=::
A4-093
d. Connect
0,
sensor cord.
8) Lower the vehicle to the floor.