Subaru 1600 Service Manual page 729

• Windshield Wiper and
Washer Switch
The windshield wiper switch and
washer switch are combined into one.
OM·830
Fig. 15-193
Windshield wiper switch
When the ignition-starter switch is set
to "ON" or "ACC" position the wiper
motor can be operated by turning the
switch knob, as shown in the illustra-
tion.
• Electric Circuit
ELECTRICAL SYSTEM
The wiper switch has two steps .
First step: low speed
Second step: high speed
Adjust the wiper speed according to
the rain condition.
The wipers are self-parking type. They
will automatically return to their
original position and stop when the
switch is turned to the "OFF" posi-
tion with the ignition-starter switch in
the "ON" or "ACC" position.
Washer switch
When the ignition-starter switch is in
the "ON" or "ACC" position, the
washer fluid will be ejected onto the
windshield glass by pushing the top of
the switch knob.
H (LYI
Intermittent wiper switch
The switch which is indicated "INT" is
located between "OFF" and "LO"
position of windshield wiper switch as
shown in the illustration.
Fig. 15-194
When setting the switch to "INT"
position, the wiper motor can be
operated intermittently.
On the other hand, the wipers can be
automatically operated approximately
four strokes after pushing the washer
switch, when the ignition-starter
switch is in the "ON" position.
Wiper switch
: L (GYI
._,- '.5
: : I
--<r-<]
'- J
6 :
OFF
ON
. ...£I (Low, High)
(j)
Fuse (20AI
kr+-~----------------~~~~
Ignition-
t t Fusible link
s ar er FL-2
switch
A25·798
Fig. 15-195
15-66