Subaru 1600 Service Manual page 644

9. Splash Board
Fig. 14-160
I) Detach upper splash board by re-
moving three tapping screws and by re-
moving one bolt which fixes both
upper splash board and lower splash
board.
2) Detach lower splash board as
follows.
a. Remove two fixing bolts (one of
them is fixing both upper and lower
splash board and is already removed
upon removing upper splash board).
b. Remove lower splash board by pull-
ing out plastic clip from the rear
wheel apron.
3) Attach (new) lower and upper
splash boards in position.
NOTE:
Apply anticorrosive agent to the back
of the screws tightening upper splash
board as shown below.
A24-713
Fig. 14-161 Applying anticorrosive
agent
BODY
A24·580
10. Body Protector
1)
Remove door trim panels.
2) Peel of sealing covers.
3) Push out clips with screwdriver.
For fender portions, push out clips
after removing mud guard.
CD
1 Clip
2 Packing
P~f-A
out
~n
A24-675
Fig. 14-162 Installation detail
4) Install (new) body protectors by
inserting clips by hand.
11. Ornaments and
Letter Marks
I) Ornaments, letter marks, etc. are
fixed by double face adhesive tapes.
Rip off the tapes by inserting a thin
but strong string like fishline.
14-49
A24-714
Fig. 14-163 Removing ornaments
2) The portions to be fitted with
ornaments, etc. are provided with
recess.
Install ornaments, etc. aligning with
the recess.
NOTE:
a. Renew double face adhesive tape
at
every removal.
b. If ornaments, etc. are deformed, re-
place them with new ones.
12. Window Moulding
1) Remove corner joint by prying it
with screwdriver.
2) Raise slightly the edge of mould-
ing, and detach the moulding while
sliding screwdriver under the mould-
ing.
3) Installation can be carried out in
the reverse order of removal, paying
attention to the follOWing.
a. Apply soapy water or kerosene to
weatherstrip.
b. In case of wide stainless steel
moulding, set work cord to the lip
of weatherstrip, and then pull out
the work cord while depressing
moulding.
Depressing
1 Work cord
2
Moulding
A24-600
Fig. 14-164 Installing moulding